Our bushings are not cheap plastic, they are Acetal plastic, also called polyacetal and polyoxymethylene (POM), They have the same life as the original bushings and will not fail like ABS or Styrene. These are made specifically for our purposes.

If your bushings are damaged or missing I have enclosed two parts that can be modified to work as bushings. Because you might not need these parts I have put them in unmodified. Follow the instructions below.

The bushing looks like this. It has been specifically tested and has the same material properties as the original plastic bushings on the Honda Odyssey cable ends.

You will need a sharp razor blade. You can't use an old one or a pocket knife. You will be removing the top flange part. Cut as shown. Be careful.

It is not critical the top of the cylinder part is completely flat. But try to cut as close to the flange part. You can then throw the flange part away unless you can use it as a nylon washer for something later.

Then cut the cylinder section of lengthwise as shown.

The cut does not have to be straight and it is okay if it cuts down at a slight angle.

When cut open the cylinder and put it on the door end of the cable.

If you have any questions please email us at:

Contact@CarCableGuy.com

We pride ourselves on our quick response to our customer questions.

Contact@CarCableGuy.com

"72010-TK8-A12 R" is another tiny product line of TitanRCK

>