If you did not purchase from THANOSZX7R on eBay, CarCableguy on Amazon, or from CarCableGuy.com you purchased counterfeit items from low quality Chinese manufacturing that is violating our copyright images and texts on this website. Please help us in limiting the low quality products and report them as counterfeit in Amazon or eBay and demand your money back.

Please follow these instructions carefully in order to ensure a proper repair that will continue to function for years to come.

Additional tools required:
Soldering iron find a link above in the "Links to Needed Tools" above
Tweezers or needle nose pliers are helpful in holding the hot items

<

Soldering

Cautions before you start:

• Test fit.
• read the instructions before you start.
• Follow the instructions.

*****The pictures show the protective coating still installed, one inch of the coating should be removed prior to solder.*****

The solder and flux are specially formulated and will work with the steel. This was developed by a metallurgical engineer to work properly and has been tested thoroughly at over 100lbs. Using other solder or flux voids the warranty and can negatively impact the ability for the barrel end remaining on the cable over time.

Pull the soldering iron out and keep the cable pushed into the end. Let cool for approximately one minute.

Contact@CarCableGuy.com

"72010-TK8-A12 R" is another tiny product line of TitanRCK

>